a3003 Gear Dust Cover (non-slipper)*

Limited run special order of these. 1\31\2020 - **We have learned that the mold we acquired makes covers that are a little on the small side so we are clearing these out wand will not run this mold again. The holes do not completely line up so the screw hole should be drilled after you have done a txt fit. You will have to remove some of the outer lip and may have to remove some of the cover near larger spur gears to prevent rubbing. - Reproduction Gear Dust Cover (non-slipper) - For models without slipper. - Protective paint film included